Download PDF
 
Wallbarn Plastic Stackable Paving Support Pads are the ideal solution for deck paving on flat roofs and walkways. They accommodate falls and changes in the level below since they are designed to stack on top of each other.
 
 

Lighter weight than the rubber paving pads, these injection moulded high density polypropylene pads are available 14mm or 17mm high, and allow a greater amount of water to run away from the underside.

Wallbarn Plastic Paving Support Pads also give the applicator a uniform spacing between the slabs to ensure fast, attractive and easy installation. There is no mechanical fixing or mortar used in this method of laying paving, as the slabs are held in place by their own weight. They can be taken up and re-laid where required without disrupting the whole paved area.

 
 

The distinct advantage of Wallbarn Plastic Paving Support Pads is the fact that they are designed to stack on top of each other. This allows applicators to continue paving on decks which are not level, or create a much higher gap between the deck and the paving, where cables may need to be laid underneath the slabs, for example.

Unlike many other so called stackable support pads, Wallbarn Plastic Paving Support Pads can be stacked up to five high
 
 

Where the deck is uneven, Wallbarn Plastic Paving Support Pads can be stacked to create uniform levels.

Providing the edges are sufficiently fixed and secured, different numbers of paving supports can be stacked at each end of the slabs to create steps.

 

Wallbarn Plastic Paving Support Pads are produced in four quadrants linked together with a small connector.

They can be easily snapped apart, creating a segment of half or quarter, for use in corners and end of runs

 
 
This eliminates wasting parts of the support pads, and gives a tidy finish to details.
 
 
Where the deck is not entirely level, Wallbarn Levelling Shims allow for fine adjustment. These are supplied 1mm, 2mm and 3mm thick
 
 
These levelling shims are interchangeable, and fit onto the heads of Wallbarn's complete range of Paving Support Pads
 
Material Injection moulded polypropylene
Bearing capacity 400 kg
Size of spacer 150mm diameter 
Height 14 mm and 17mm
Thickness of lugs
(joint width)		 5mm
Drainage Channels
(underneath)		 1 x 9mm wide holes per quadrant
Quantities 17mm high sold in boxes of 200
14mm high sold in boxes of 240
Both boxes weigh 12 kg
 
Advantages of Wallbarn Plastic Stackable Paving Support Pads
 
  • Lightweight and easy to handle
  • Correct positioning of paving slabs and holding them securely in place.
  • Uniform spacing between paving slabs
  • High clearance of paving slabs from the base structure.
  • Water drainage between slabs, and below the paving level.
  • Interlocking, allowing stacking, for laying paving to falls.
  • Very easy to snap segments apart for corners etc
  • Labour saving
  • Paving not fixed, allowing slabs to be removed easily
 
 
 
To download our current brochure (in Adobe Acrobat PDF format) please click here.
 
 

paving :: paving support :: paving pad :: pave pad :: waterproofing :: flat roof :: green roof :: drainage :: expansion joint :: protection board :: protection :: geotextile :: caro :: harmer :: buzon :: servipak :: timber decking :: timber decking support :: bituminous protection board :: timber decking paving slabs :: hardwood timber decking paving slabs :: rubber protection board :: membrane protection :: foundation waterproofing :: roof waterproofing :: waterproofing material :: drainage sheet
  © Copyright 2006, Wallbarn Ltd, All Rights Reserved. Designed by Footprint